Properties
Application
The heated gas sampling probes PSG Basic Probe Duo are used for continuous extractive gas analysis. They enable continuously trouble-free representative sampling of hot, predominantly low or medium dust and water vapor loaded gases – high dust load with additional options. Typical applications are emission measurement, process monitoring, control and optimization. The new PSG Basic Probe Duo offers 2 independent, sample gas outlets.
By loading the video, you accept YouTube's privacy policy.
Learn more
Technology
The intelligent design with optimum gas guidance enables the filtration of sample gas at the outer 212 cm2 filtration surface (largest worldwide) as well as quick and easy filter change without tools and dismounting of the heated sample line. Easy maintenance of the PSG Basic Probe Duo is enabled due to its newly space-saving bracket design, which also can be used to lift a sticking filter housing lid. The holohedral tight high- performance ring heater in combination with the tight thick-walled glass fiber insulation jacket ensures a homogeneous heating of the complete PSG Basic Probe Duo up to 250 °C. The self-regulated version has a factory setting of 160 °C (standard) up to 180 °C. Regulated temperature enables up to 250 °C and is recommended especially in case of high (acid) dew point or to avoid salification (especially if sample gas includes low acidic / alkaline components as NH3 leading to ammonium carbonate): Sophisticated PSG Basic Probe Duo design – long lifetime.
Functions
Extreme large filter surface & homogeneous heating ensures that dust will always be separated reliably in the PSG Basic Probe Duo without condensation of water vapor thus avoiding blocking of the filter. Due to large filters with 0.1 resp. 0.3 µm porosity the PSG Basic Probe Duo can be used for applications with up to 3 g/m3 dust and 10 g/m3 with pre-filter or single stage back purge. The 0.3 µm surface coated SiC ceramic filter enables best thermal & chemical resistance also for tough applications. The standard calibration resp. test gas connection enables the use of the PSG Basic Duo Probe within emission monitoring systems acc. to EU Regulations 2000/76/EG & 2001/80/EG: TI Air (TA Luft), 13th & 17th BImSchV (large combustion plants, waste incineration). PSG Basic Probe Duo design allow small, medium or high dust contents.
You may also be interested in
Sampling Tubes in various materials and length for different applications
6 mm / 8 mm Pressure Reduction Valve for Protection of the Sampling System
Self limiting Probe with 180°C holding temperature for use in IP 65 housing and explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 and IEcEX
Self limiting Probe with 180°C holding temperature for use in IP 65 housing and explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 and IEcEX
Self limiting mobile Probe heated up to 180°C holding temperature for temporary CEMS
Controlled Probe up to 200°C holding temperature and double back purge for Process measurement with high dust load
Controlled DeNOx Probe up to 315°C holding temperature for SCR and SNCR applications with separator vessel for Ammonia salts
Self limiting Probe with 90 °C holding temperature with explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 Gb
Controlled Probe up to 315°C holding temperature for Process and Emission measurement with high dust load
Self regulating or controlled Probe heated up to 200°C holding temperature for CEMS and low to medium dust load
Temperature controlled Heated Sample Tubes for 180°C Holding Temperature
PID Temperature Controller for PSG Gas Sampling Probes and Heated Lines (tabletop device)