Properties
Application
The portable heated gas sampling probes series Probe Mobile are used for continuous extractive gas analysis. They enable trouble-free representative sampling of hot predominantly dust and water vapour loaded gases at changing locations. Typical applications are emission measurement, process monitoring and process optimization as well as inspection of permanently installed measurements.
Technology
The intelligent design with optimum gas guidance enables the filtration of sample gas at the outer filtration surface of 141cm2 (largest on the market for portable probes) as well as comfortable and quick filter change without tools and dismounting of the heated sample line. Extremely simple maintenance of the Probe Mobile is enabled due to unscrewing the complete filter unit at the external rotary knob. The well insulated self-regulating high performance heating elements always ensures a homogeneous heating of the complete Probe Mobile to 180°C.
Functions
Due to the largest filtration surface on the market in combination with the homogeneous heating, dust will always be separated reliably in the Probe Mobile without condensation of water vapour and therefore without blocking of the filter. Due to the large ceramic filter with 2µm porosity the Probe Mobile is applicable for dust concentrations of up to 1g/m3. For elevated dust concentrations of up to 10g/m3 the Probe Mobile has a back-purge port as standard. A stainless-steel filter cartridge filled with glass wool is available for applications with soot and taar (e.g. diesel fuel exhaust gas). The standard calibration resp. test gas connection enables the use of the Probe Mobile within emission measuring systems according to 13. and 17. BImSchV (EU-regulations 2000/76/EG and 2001/80/EG.
You may also be interested in
Sampling Tubes in various materials and length for different applications
6 mm / 8 mm Pressure Reduction Valve for Protection of the Sampling System
Self limiting Probe with 180°C holding temperature for use in IP 65 housing and explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 and IEcEX
Self limiting Probe with 180°C holding temperature for use in IP 65 housing and explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 and IEcEX
Controlled Probe up to 200°C holding temperature and double back purge for Process measurement with high dust load
Controlled DeNOx Probe up to 315°C holding temperature for SCR and SNCR applications with separator vessel for Ammonia salts
Self limiting Probe with 90 °C holding temperature with explosion proof for ATEX Zone 1 II 2G Ex d IIC T3 Gb
Controlled Probe up to 315°C holding temperature for Process and Emission measurement with high dust load
Self-regulating or regulated duo probe up to 250°C holding temperature for simultaneous sampling from 2 outlets at low to medium dust loadings
Self regulating or controlled Probe heated up to 200°C holding temperature for CEMS and low to medium dust load
Temperature controlled Heated Sample Tubes for 180°C Holding Temperature
PID Temperature Controller for PSG Gas Sampling Probes and Heated Lines (tabletop device)